Epoxy Terminated Silicone Fluid 1. Improve electrical performance, reduce internal stress, etc. Epoxy Silicone Fluids,Epoxy Terminated Silicone Fluid,Polyether Modified Silicone Fluid,Linear Polyether Modified Silicone Fluid Suzhou Cheerchem Advanced Material Co., Ltd. , https://www.szcheerchem.com
Technical Parameters:
Input power: three-phase four-wire AC380V
Output voltage and current:
1. Three-phase AC100V output (fixed value) A group of two, three-phase AC0–10A output (10A, adjustable value> group 3, AC voltage output three-phase AC0–400V, 220V, current is less than 10A, group 4, DC operating voltage output DC0-260V group 5, single-phase AC220V output (socket) two groups 6, three-phase AC380V output (fixed value, terminal) a group of 7, single-phase 24V, 36V, 110V, 220V DC fixed output Group 8, external dimensions: 550×570×1040mm
9, weight: 55kg
Operating instructions Take a test of a single-phase AC voltage meter as an example:
1. Connect input power AC380V
2. Check and confirm if the wiring is connected to the main power switch 3. Return the regulator to zero and press "switch on",
4. Then press the "switch on" switch on the panel to switch the operating voltage 5. Slowly adjust the output adjustment knob to raise the voltage to the required value and observe the voltmeter condition.
6. After the test is completed, press the “opening†twist of the AC operating voltage on the panel. Then, disconnect the main power switch:
1. Connect the “AC380V power input†to the three-phase four-wire network. Connect the ground wire to the earth network. Never connect the ground wire to the neutral wire or access the housing of other equipment. It will bring great danger to the subsequent test work. As we all know, if the equipment fails or the equipment shell is live, the operator will contact the live body as if it were connected to a 380V power grid.
2. Overcome the three major shortcomings of ordinary amino silicone oil, such as yellowing, non-hydrophilicity and demulsification sticking roller.
3. Good demoulding effect.
4. Good affinity for fibers and fillers, which can increase the interface bonding force and improve the strength of composite products.
5. It is a broad-spectrum tackifier for addition-molded silicone rubber, which is very effective for the tackification of aluminum and glass.
The high and low voltage switchgear power-on test bench is used for high and low voltage switchgear manufacturers to conduct various power test before leaving the factory for the high and low voltage switchgear produced. It can provide a variety of AC and DC power supply to facilitate the detection of switchgear and improve work efficiency.