Versatile Custom Paperboard Boxes And Folding Cartons Folding Paperboard Boxes,Paperboard Boxes Packaging,Corrugated Paperboard Boxes Jiangsu Hualong Printing Co.;Ltd , https://www.hlpackingtop.com
The simulation results of the interference part of the soft tooth and the rigid tooth can be clearly seen through observation and comparison. Because the inclination of the wave generator and the flexible wheel is accompanied by the inclination angle, the interference is obvious, and the author partially refines the unit. The rough wheel profile is compared to obtain the approximate interference value, and the most severely interfering tooth also has an interference depth of approximately 0.05 mm in the normal direction of the tooth surface in the flank portion, which will seriously affect the stability of the transmission during the harmonic transmission process. Sex, and due to the existence of its interference, a large amount of heat is generated in the transmission process, which has a great influence on the life of the harmonic gear; the corresponding new type of rigid wheel corresponds to good interference, and no interference occurs. In the actual design, the length of the head gap can be appropriately adjusted to ensure zero interference and improve the bearing capacity without undercutting, thereby increasing the number of tooth engagement of the flex wheel and reducing the load of the meshing teeth at the same time. Improve the life of harmonic gears.
Combining geometric design and elastic numerical analysis, numerical simulation of the assembly process of the wave generator, analysis of the tooth meshing state after the harmonic deformation of the harmonic gear, and by calling some of the results of the simulation results, the Caesar air compressor can improve the design of the rigid wheel. The research method has the following characteristics: 1) Elastic numerical analysis of the harmonic gear meshing state, overcoming the shortcomings of static geometric analysis and actual meshing state; 2) Visualizing the meshing state of the gear to clearly observe the interference problem in the meshing; 3) The simulation results are called, and the design is based on the simulation, which is highly targeted. In this paper, the cup-shaped flexible wheel, the elliptical wave generator, and the modified front and rear wheel are modeled. The finite element method is used to analyze the static contact of the assembly process, which overcomes the shortcomings of simple geometric analysis and makes the harmonic gear The analysis of the meshing state and the actual meshing state tend to coincide. At the same time, the paper analyzes the causes of interference in the process of harmonic gear transmission. After the finite element analysis, the data is improved on the rigid wheel, and the meshing state of zero interference is obtained. The proposed research methods and results are available to engineers in the design of harmonic gears. In addition, the load capacity of the harmonic gear can be improved by appropriately adjusting the top clearance of the wheel.