1, drive shaft and bushing wear repair Gear pump drive shaft and bush wear, with the gap increases, will certainly affect the pump oil. In this case, you can repair the drive shaft or bushing method to restore its normal with the gap. If the drive shaft wear slightly, simply press the old bushing and put on the standard size bushing, with the gap can be restored to the allowable range. If the drive shaft and bushing wear serious and serious with excessive clearance, not only to replace the bushing, and the drive shaft also applies chrome or vibration welding method to increase its diameter, and then grinding to the standard size, recovery and bushing With the requirements. 2, the repair of the lubricating oil pump shell crack repair Shell cracks can be cast 508 nickel-copper welding electrode repair. Welds to be close and yuan stomatal, with the flatness of the pump cover with no more than 0.05 mm flatness. 3, active shaft bushing hole and driven shaft hole wear repair Drive shaft bushings wear holes, reaming methods can be used to eliminate wear marks, and then with increased to the appropriate size of the bush. Follower shaft wear and tear also reaming method to eliminate wear marks, and then press the hole reaming the actual size of the preparation of the driven shaft 4, pump chamber cavity repair Cavity pump chamber wear, the general approach to the lumen set to repair, about to enlarging the cavity after the set with cast iron or steel bushings. Inlaid, the cavity enamel 5, the valve seat repair: pressure limiting valve with a ball valve and plunger valve two. Ball seat wear, the ball can be placed on a valve seat, and then gently tap the metal ball, until the ball valve and valve seat so close. If the valve seat is worn seriously, first remove the worn marks by reaming, and then use the method to make it close. Plunger seat wear, you can put a little valve sand grinding until close together. 5, the pump cover repair Work plane repair: If the pump cover wear a small work surface, manual grinding method can be used to eliminate signs of wear and tear, that is, put a little valve on the platform or thick glass plate sand, and then put the pump cover on the ground until the wear marks disappear, The work surface is flat. When the pump cover working surface wear depth of more than 0.1 mm, should be taken after the turning grinding method to repair. 1.Introduce of truck mounted Water Well Drilling Rig Truck Mounted Drilling Rig,Truck Mounted Rig,Truck Mounted Auger Drill,Truck Mounted Borehole Drilling Rig JIANGSU XI TEC ENVIRONMENTAL&DRILLING EQUIPMENT COMPANY CO.LTD , https://www.sjxitecdrilling.com
1.Water wells multi-function rig is truck mounted type, also with air compressor on truck, easy move high efficiency and multifunction of drill hole equipment, it is mainly suitable for drilling Wells, geothermal air-conditioning hole hole and other USES.
2.2,The rig adopts the new type of hydraulic technology, supporting the rotary hydraulic motor with high torque and big diameter hydraulic oil cylinder, a factory engine to provide power for hydraulic system, two levels of intake air filter and air compressor design, prolong the service life of diesel engine.
3.Unique pump group design and convenient maintenance, reduce the maintenance cost.
4.Centralized control of the hydraulic control console, convenient operation.
5.Independent module design, can make the drilling rig is installed on the truck, to increase its mobility.
6.Combined the locator, but according to different types of drill pipe and is adjusting the
positioning tray, guarantee the positioning centering accurate and reliable.