Hydraulic Spring Compressor,Hydraulic Coil Spring Compressor,Hydraulic Strut Spring Compressor,Hydraulic Strut Compressor WUQIANG HONGMA TOOLS MANUFACTURE CO., LTD , https://www.hmrapairtools.com
Recent customer feedback equipment installation after the leakage problem is still due to improper installation practices caused pure water leakage after installation, leakage fault point is located in the pressure tank Anhui copper ball valve Department. The following analysis of the reasons for the leakage: The first, two-point shear is not standardized, defective nozzle, skew, burr will lead to interface leakage; The solution is to use a dedicated tube cutter to cut the two tubes. The second, two points failed to insert the place, leaking; solution is to find the hand, visual size. The tube just inserted into the connector 10mm, will be blocked, and then need to insert the connector force, will once again in-depth 6mm. Third, the ball valve installation, the lack of seals; solution is the seal and ball valve supporting the use of less seals will leak. Fourth, the ball valve and pressure tap water nozzle installed entangled raw material; solution is that this step does not allow entangled material strip, and tighten the ball valve by hand, watch the water leakage can be the fifth, the installation process ball valve and pressure barrel Faucet docking faucet; solution is to ensure that the center line of the two mating parts must be installed in the same axis, and hard uniform installation