Description:
The ignition analyzer can be used to
measure each cylinder speed of the car engine, high voltage ignition coil
ignition voltage and the injection time of each cylinder. It is induction type,
without dismantling any pats, you can test the general distributor type SPW and
ignition coil type COP. It can dynamically display the parameters and display
the maximum and minimum range.
1. Measures RPM
Functions:
Features: Ignition Tester Ignition Tester,Ignition Coil Tester Tool,Ignition Coil Test,Ignition Spark Tester Shenzhen Cartrend Technology Co, Ltd , https://www.cartrendthings.com
Turn the steering wheel to the left to reverse the back of the tire. When the vehicle is stopped, turn the steering wheel to return the tire. When the left rear wheel reaches the white line on the outside of the parking space, stop the retreat.
Move the car closer to the right side, and turn the steering wheel to the left to the end. Slowly retreat. Before the vehicle is parallel to the road shoulder, turn the car back to the right and stop the vehicle parallel to the shoulder. Be careful not to collide with the rear car. It is important that semi-trailers belong to large-scale vehicles to be careful to wipe them.
2. Measures spark volt
3. Measures spark burn time
4. Advanced microcontroller technology
5. No ground wire connections required
1. Minimum and
Maximum functions (For COP and SPW modes)
It maintains a continuous record of the minimum and maximum readings of the
function currently selected. To display the Minimum and Maximum readings of the
main display, if not already selected press` Secondary Function/Capture` Button
momentarily. To reset the Minimum and Maximum readings, press the `Power
ON/OFF/Reset` button momentarily. These values are also rest when turning to
[0".
2. Spark KVOLT
Calibration function (For Cop mode only)
It requires the user to calibrate the instruments in order to measure spark
KVOLT in coil on plug and coil near plug ignition systems.
This calibration uses the measurement values obtained during the procedure to
find the optimal measuring parameters or a particular type of ignition module,
and compensates for differences in waveform and signal strength.
Once the Ignition Tester has been calibrated on one of the ignition modules of
the engine being diagnosed, all the subsequent measurement of spark KVOLT will
be relative to the calibration value.
1. Capacitive
pick-up
2. Flexible probe
3. Protective rubber holster
4. LCD display
5. Power ON/OFF/RESET button
6. Secondary Function/Capture button
7. Ignition system button
8. Main Function/Calibrate button
9. Engine Cycles button.
Semi-trailer and adjacent vehicle side-by-side: Confirm that the distance from the neighboring car is about 1 meter. After confirming the safety at the rear, it will be reversed in a straight line. When the rear bumper of the vehicle is side by side, the retreat will stop. Techniques for several types of parking methods on the warehouse-style semi-trailer Turn right to the steering wheel and reverse to the target position: With the vehicle stopped, turn the steering wheel to the right. Relax the brake pedal slightly and use the creep function of the semi-trailer to reverse. When the left side of the car body reaches the point A extension line, it stops.